Check whether the raw materials are consistent. Granular production is carried out with reference to low four materials.

1. Plug in the machine and press the power on button. The engine should start and the mold should rotate.

2. 
   

If the engine does not run, immediately press the stop button and check or investigate the cause of the fault

Question.

2. Place a container (such as a bucket) into the particle chute.

3. Place a small amount of source material into the feed tube. Be sure not to fill too many materials at once, because

The machine may become clogged.

After a moment, the particles will fall into the particle chute and collect. Particles can reach

The final hardness is only after cooling.

5. Place the remaining material and replace the container filled with particles.

6. Do not stop the machine during the shot pressing operation (except in emergency situations), otherwise

The machine will be blocked to restart.

7. Press the stop button to stop the machine.

8. Clean the machine once. This step is important as if the raw material is cold

They will remain completely inside the roller box and will be difficult to remove.

Note: If satisfactory particles are not obtained during the first trial run of the machine, the particles

The resulting should be reintroduced into the feeding tube. More ingredients should be added, such as sawdust,

Thereby improving the production quality of pellets.